院报 ›› 2018, Vol. 35 ›› Issue (3): 122-128.DOI: 10.11988/ckyyb.20171234

• 岩土工程测试与监测 • 上一篇    下一篇

弱胶结地层立井井筒变形监测研究

吕显州1a, 王渭明1a, 贾海宾2, 潘格林1a, 赵增辉1b,1c   

  1. 1. 山东科技大学 a.土木工程与建筑学院;b.矿山灾害预防控制省部共建国家重点实验室培育基地;c. 矿业与安全工程学院,山东 青岛 266590;
    2.山东新巨龙能源有限责任公司,山东 菏泽 274918
  • 收稿日期:2017-10-24 出版日期:2018-03-01 发布日期:2018-03-16
  • 通讯作者: 王渭明(1954-),男,江西临川人,教授,博士,博士生导师,主要从事岩石力学与地下工程稳定性控制方面的教学与研究。E-mail:wang@sdust.edu.cn
  • 作者简介:吕显州(1990-),男,山东滕州人,博士研究生,主要从事隧道及地下工程监测及稳定性控制方面的研究。E-mail:lvxianzhou1990@163.com
  • 基金资助:
    国家自然科学基金项目(41472280);山东省中青年科学家科研奖励基金(BS2015SF005)

Deformation Monitoring of Shaft Lining in Weakly Consolidated Strata

LÜ Xian-zhou1, WANG Wei-ming 1, JIA Hai-bin2, PAN Ge-lin 1, ZHAO Zeng-hui3,4   

  1. 1.College of Civil Engineering and Architecture,Shandong University of Science and Technology,Qingdao 266590,China;
    2.Shandong Xinjulong Energy Co.,Ltd.,Heze 274918,China;
    3.State Key Laboratory of Mining Disaster Prevention and Control Co-founded by Shandong Province andthe Ministry of Science and Technology,Qingdao 266590,China;
    4.College of Mining and SafetyEngineering,Shandong University of Science and Technology,Qingdao 266590,China
  • Received:2017-10-24 Online:2018-03-01 Published:2018-03-16

摘要: 针对弱胶结深厚松散地层立井井筒的灾变防控问题,基于双向受压混凝土强度破坏准则和厚壁圆筒空间轴对称问题位移解,研究新巨龙煤矿立井井壁的变形破裂极限值。采用深井多层位自动变形监测系统,在新巨龙煤矿副井井筒深度范围内选择了3个层位进行井筒变形连续动态监测,并评估了其井壁状态。结果表明:极限破坏状态下井筒内壁变形值为2.369 mm;在弱胶结地层底部含水层与基岩段交界处立井井壁变形量最大,约为井壁变形极限值的82.5%;井壁变形增量在一定范围内波动,其变形属于弹性变形。最后,根据监测得到的变形量反演了井筒的受力状态,所得井壁最大变形量区域的附加应力值小于井壁极限抗压强度。工程实践表明变形监测结果能够真实地反映井壁的受力状态,监测系统能够实现井壁安全状态的实时动态评估。

关键词: 弱胶结地层, 立井井筒, 井壁变形, 监测系统, 状态评估

Abstract: Shaft lining in thick weakly consolidated strata is featured with large deformation and repeated damage after repair. Based on the concrete strength failure criterion under biaxial compression and analytical solution for spatially axisymmetric problem of a thick-walled cylinder, we obtained the limit value of damage of the shaft lining in Xinjulong coal mine. We selected three formations to carry out monitoring by a multi-layer automatic deformation monitoring system for the auxiliary shaft in Xinjulong coal mine, and evaluated the status of the lining. Results show that the deformation of the shaft lining under the condition of ultimate failure is 2.369 mm. The shaft lining located in the border of the bottom aquifer and the bedrock subjects to the most severe deformation, about 82.5% of the deformation limit. The shaft lining deformation increment fluctuates in a certain range belonging to elastic deformation. Finally, we inversed the stress state according the deformation value of the shaft lining. The obtained value of additional stress is lower than the ultimate compressive strength. Long-term project practice shows that the deformation monitoring results could reflect the real stress condition of the shaft lining. Moreover, the monitoring system could realize real-time dynamic evaluation of the shaft lining status.

Key words: weakly cemented strata, shaft lining, deformation, monitoring system, condition evaluation

中图分类号: 

Baidu
map