为研究嵌岩扩底短桩的抗拔承载性能,在现场完成了4根扩底短桩的抗拔静载试验,详细地分析了单桩Q-s曲线,并将现行规范计算的极限抗拔承载力与现场试验结果相比较。在通过PLAXIS 3D软件验证数值模拟结果与现场试验结果吻合的基础上,进一步深入探讨了水平荷载对扩底短桩抗拔承载特性的影响。结果表明:扩底短桩的Q-s曲线呈陡变型,极限状态桩顶上拔位移与桩径之比的平均值为1.94%;现行规范计算结果过于保守,公路规范相比其它规范计算结果与试验结果较为接近;当水平荷载与上拔荷载的比值η分别为10%,20%,30%时,极限抗拔承载力呈线性减小,相比η=0时分别减小8.3%,16.7%,25.0%。研究结果对优化桩基设计有重要的理论意义和工程应用价值。
Abstract
Static uplift tests were performed on four short piles with enlarged bottom to investigate the uplift bearing characteristics of rock-socketed short piles with enlarged bottom. The Q-s curves of single pile obtained from the tests were analyzed in detail, and the field test result was compared with the ultimate uplift bearing capacity calculated by current codes. The field test results were verified consistent with numerical results by PLAXIS 3D. On this basis, the influence of horizontal load on the uplift bearing capacity of short pile with enlarged bottom was examined. The Q-s curves of short piles with expanded-bottom are steep, and the average ratio of uplift displacement to pile diameter is 1.94% in limit state. The calculation results of present codes are too conservative. Comparing with other codes, the calculation results of highway codes are closer to the test results. When η, the ratio of horizontal load to uplift load was 10%, 20% and 30%, respectively, the ultimate uplift bearing capacity of the pile decreased linearly by 8.3%, 16.7% and 25.0% respectively compared to that when η=0.
关键词
嵌岩 /
扩底短桩 /
抗拔承载性能 /
现场试验 /
数值模拟
Key words
rock-socketed /
short pile with enlarged bottom /
uplift bearing behavior /
field test /
numerical simulation
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
[1] MEYERHOF G G, ADAMS J I. The Ultimate Uplift Capacity of Foundations[J]. Canadian Geotechnical Journal, 1968, 5(4): 225-244.
[2] DESHMUKH V B, DEWAIKER D M, CHOUDHURY D. Computations of Uplift Capacity of Pile Anchors in Cohesionless Soil[J]. Acta Geotechnica, 2010, 5(2): 87-94.
[3] CHATTOPADHAY B S, PISE P J. Uplift Capacity of Piles in Sand[J]. Journal of Geotechnical and Geoenvironmental Engineering, ASCE, 1989, 112(9): 888 -904.
[4] KULHAWY F H, KOZERA D W, WITHIAM J L. Uplift Testing of Model Drilled Shafts in Sand[J].Journal of the Geotechnical Engineering Division,ASCE,1979,105(1): 31-47.
[5] BALLA A. The Resisitance to Breaking out of Mushroom Foundation for Pylons[C]∥Proceedings of the 4th International Conference on Soil Mechanics and Foundation Engineering. London, August 12-24, 1957: 69-76.
[6] EL SAWWAF M, NAZIR A. The Effect of Soil Reinforcement on Pullout Resistance of an Existing Vertical Anchor Plate in Sand[J]. Computers and Geotechnics, 2006, 4(1): 1-10.
[7] 崔 强, 邢 明, 杨文智, 等. 喀斯特地区短桩锚杆复合基础现场抗拔试验及设计方法研究[J].岩石力学与工程学报,2018,37(11):2621-2630.
[8] 王卫东, 吴江斌, 王向军. 基于极限载荷试验的扩底抗拔桩承载变形特性的分析[J].岩土工程学报,2016,38(7):1330-1338.
[9] 宋 兵, 蔡 健. 桩-岩摩擦黏着特性的试验与分析[J].岩土力学,2011,32(8):2313-2317.
[10]王钦科, 马建林, 胡中波, 等. 浅覆盖层软质岩中抗拔桩承载特性现场试验研究[J].岩土力学,2019,40(4):1498-1506.
[11]文松霖. 铅直、水平荷载作用下扩底桩的承载机理[J].raybet体育在线
院报,2004,21(5):24-31.
[12]何思明, 吴 永, 李新坡. 嵌岩抗拔桩作用机制研究[J].岩土力学,2009,30(2):333-337.
[13]何思明, 张晓曦, 王东坡. 分层地基中抗拔桩破裂面的确定方法与极限抗拔承载力计算方法研究[J].岩土力学,2012,33(5):1433-1437.
[14]JGJ 106—2014,建筑基桩检测技术规范[S].北京:中国建筑工业出版社,2014.
[15]JGJ 94—2008,建筑桩基技术规范[S].北京:中国建筑工业出版社,2008.
[16]GB 50007—2011,建筑地基基础设计规范[S].北京: 中国建筑工业出版社,2011.
[17]TB10093—2017,铁路桥涵地基与基础设计规范[S].北京: 中国铁道出版社,2017.
[18]JTG D63—2007,公路桥涵地基与基础设计规范[S].北京: 人民交通出版社,2007.
[19]DL/T 5219—2005,架空送电线路基础设计技术规定[S].北京: 中国电力出版社,2005.
[20]柳晓科, 鹿 群, 路士伟, 等. 低裙式吸力桩真空沉贯力及抗拔承载力[J].岩土力学,2018,39(6):2089-2098.
[21]乾增珍, 鲁先龙, 丁士君. 风积沙地基斜柱基础上拔水平力组合荷载试验[J].岩土力学,2009,30(1):257-260.
PDF(3976 KB)
